Shooting World Forums banner
1 - 1 of 1 Posts

· Registered
85 Posts
Discussion Starter · #1 ·
I was working up a coffee can full of 9mm Luger brass for reloading and discovered a 9mm Mak case that had sized and flared perfectly.

Has anyone used 9mm Mak brass for 9mm Luger?
When I get a chance I will build a couple dummy rounds.

I may have reloaded some in the past and not been aware of it. .380 Autos mixed in show up readily when sizing. These Mak cases do not. Reading each and every head stamp is a PITA.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.